Honda HHT25S Manual page 36

HHT25S•HHT35S
SEMI-MATIC CUTTING LINE HEAD
1. Clean any mud, dirt, debris, etc., from around the trimmer head
area. Otherwise, servicing the trimmer will be more difficult.
2. Locate the half-round locking hole on the spool.
3. It may be necessary to lightly rotate the spool in the direction of
the arrow about 1/8 turn until the spool stops.
4. Hold the housing securely, then continue to rotate the spool in
the direction of the arrow an additional 1/4 inch or the width of
the channel to unlock the spool from the housing.
5. Lift the spool out of the housing, and then remove any
remaining line from the spool.
6. Measure approximately 6 meters (20 feet) of line, and then
thread one end though the hole in the ridge on the spool. Pull
the line until the two line lengths are equal.
SPOOL
NYLON LINE
MAINTENANCE
HALF-ROUND
LOCKING HOLE
HOUSING
CHANNEL
SPOOL
3-7