Honda HHT25S Manual page 70

HHT25S•HHT35S
CLUTCH ASSEMBLY
NOTICE
To avoid flywheel fan blade damage, position the strap wrench
fulcrum at the flywheel magnetic parts.
DISASSEMBLY
Holding the flywheel with a commercially available strap wrench,
remove the clutch bolt and remove the clutch assembly.
REASSEMBLY
1. Install the clutch assembly so that the "
shown.
2. Be sure to set the clutch washer between the clutch assembly
and flywheel.
3. Holding the flywheel with a commercially available strap
wrench, tighten the clutch bolt to the specified torque.
TORQUE: 9.8 N•m (7.2 ft•lb)
FLYWHEEL
NOTICE
To avoid flywheel fan blade damage, position the strap wrench
fulcrum at the flywheel magnetic parts.
DISASSEMBLY
1. Holding the flywheel with a commercially available strap
wrench, remove the 7 mm flange nut from the flywheel.
2. Remove the flywheel using a commercially available flywheel
puller.
NOTICE
Do not remove the flywheel by tapping it with a hammer.
STARTER PULLEY/ CLUTCH / IGNITION COIL / FLYWHEEL

" mark is visible, as
7-7