Honda HHT25S Manual page 114

HHT25S•HHT35S
DISASSEMBLY/REASSEMBLY
Use a heat gun or submerge the entire gear case in a pan of oil. Heat the oil to 80°C ~ 90°C (176°F ~ 194°F). When the entire gear
case becomes hot, remove the gear case from the oil and disassemble. For reassembly, reverse the procedure and fill the gear case
with the NLGI #2 grease.
Do not heat the oil above 90°C (194°F).
The entire gear case becomes hot. Be sure to wear protective gloves during this procedure.
RADIAL BALL BEARING
609ZZ C3
INSTALLATION:
Shielded both sides
INPUT SHAFT
REMOVAL: Remove the input shaft
first, and then remove the output shaft.
Bevel gear: 17 teeth
DRIVE CABLE STOP
REMOVAL: This part is pressed into the
input shaft and is not normally removed.
GEAR CASE FILL HOLE
Recommended grease:
Fill the gear case with NLGI No. 2
general purpose grease.
Grease capacity: 15 g (0.53 oz)
8 x 10 mm HEX BOLT
TORQUE: 10 N•m (1.0 kg•m, 89 in•lb)
RADIAL BALL BEARING
6201/C3
28 mm INTERNAL CIRCLIP
OIL SEAL
• 32 mm OD
• 17 mm ID
• 8 mm thickness
CUTTING ATTACHMENT / GEAR CASE
10 mm EXTERNAL CIRCLIP
INTERNAL CIRCLIP
RADIAL BALL BEARING
INSTALLATION: No shield on either side
5 x 25 mm BOLT/WASHER (2)
TORQUE:
5.6 N•m (0.60 kg•m, 50 in•lb)
5 x 12 mm BOLT/WASHER
TORQUE:
2.5 N•m (0.25 kg•m, 22 in•lb)
RADIAL BALL BEARING
6290P C3
BEVEL GEAR
Bevel gear: 21 teeth
OUTPUT SHAFT
REMOVAL: Remove the
input shaft first, and then
remove the output shaft.
•10 splines
•10 x 1.25 mm left hand
threads
10-9