CAM PULLEY / CYLINDER HEAD COVER / LOWER CRANKCASE
CAM PULLEY
REMOVAL
1. Remove the spark plug and the head cover
2. Set the piston at top dead center (TDC) of the compression
stroke.
When the piston is at TDC of the compression stroke, the
flywheel alignment mark "" will align with the fan cover bolt
hole. Also, the cam pulley alignment marks will be positioned
as shown.
3. Push the cam pulley shaft out from the valve spring side using
a pin approximately 2 mm in diameter.
4. Remove the timing belt from the cam pulley, and remove the
cam pulley.
8-2
(P.
3-11,
P.
8-1).
HHT25S•HHT35S