Operating the system
Turning on/off the system
4.3 Turning on/off the system
4.3.1 General
The system is ready for examination within two minutes after the system has been turned on.
Before starting the system, check that the emergency stop is not activated. When the system
starts up, light indications and displays are lit.
4.3.2 Turn on the system
Perform the following procedure when starting up the X-ray system.
Note!
Before turning ON, check the connection between the image system and the X-ray system.
In addition, check that the other connected devices are correctly connected. If there is any
failure, connect them correctly.
1. Press the power [ON] button on the generator control console.
2. Press the power button of the image control unit.
3. The image system will be started. See the Image System Manual for further information.
4. Confirm that the image system has started normally by checking the status icons.
OMNERA®
A
Fig. 4-2 Power on button — generator control console
Fig. 4-3 Power button — image control unit
0180-095-418-EN Rev. 6.1
Page 82
Operator´s Manual
2020-09-18