Safety Zone, Definition; Safety Zone, Table - Canon OMNERA 400T Operator's Manual

Safety

Safety Zone, Definition

2.12 Safety Zone, Definition
At installation, a safety zone is defined.
The intention of the safety zone is to prevent collision with the patient, during automatic
movements (tracking) downward. When the lowest part of the OTC is above the safety zone
automatic movements is allowed. When it is inside the safety zone, automatic movements is
not allowed.
The safety zone (1) does not affect the function of the manual movement (no tracking) or the
automatic movement (tracking) upward.
1. Safety zone
2. Table

2.12.1 Safety Zone, Table

2.12.1.1 Table 0181
The automatic movement downward (tracking) is not possible in safety zone (1)
The safety zone (1) does not affect the function of the automatic movement upward
(tracking).
2.12.1.2 Table 0055 (option)
There is a squeezing risk when driving the table to a low position.
Within the safety zone the table moves at a low speed, to increase the possibility for the user
to react in case of a collision (squeezing). The safety zone appear 120 mm above the floor,
according to IEC 60601-1. The safety zone automatically stops the two column table, 120
mm above the floor. The user must then activate the foot control again to make the table
move further down.
OMNERA®
4
Beta
2
Fig. 2-21 Safety zone
0180-095-418-EN Rev. 6.1
Page 36
3
Alpha
1
3. Ceiling stand
4. Wallstand
Automatic
movement
allowed
Automatic
movement
not allowed
downward
Operator´s Manual
2020-09-18