Operating The Table; General; Functional Description, Closed Table 0181 - Canon OMNERA 400T Operator's Manual

4.4 Operating the Table

The two column table 0055 is described in 3.16 Table control elements

4.4.1 General

CAUTION!
Do not place the device where dust may cause malfunction to the power source.
Note!
The Table shall only be operated by trained radiographers, service technicians or product
specialists.

4.4.2 Functional description, closed table 0181

The control of the table is positioned on the lower part of the vertical lift as a kick box or on
the floor as a foot control, there is an optional hand control. The controls are used for ena-
bling and disabling of functions of the table. These functions are described below.
4.4.2.1 Movements
The table can be moved in Z-direction for up and down movements and in X- and Y-direction
for longitudinal and lateral movements. See figure below for different controllers.
Operator´s Manual
2020-09-18
Operating the system
0180-095-418-EN Rev. 6.1
Page 91
Operating the Table
OMNERA®