Operating The System; General - Canon OMNERA 400T Operator's Manual

Manual-positioning digital radiographic system
Hide thumbs Also See for OMNERA 400T:
Table of Contents

Advertisement

4 Operating the system

4.1 General

WARNING!
If any item is removed from the wall stand, e.g. the detector or lateral armrest, the wall
stand will become unbalanced.
When the brake is released, part of the wall stand will move upward and can cause
injury.
The operation should be performed by trained personnel.
WARNING!
Because of squeezing hazards, motorized movements are only allowed if patient and
system are observed by personnel.
WARNING!
During activation of motorized movements, the area under the table shall be free from
obstacles, because of squeezing hazards.
WARNING!
Detector, FPD (Flat Panel Detector) or grid:
• Check that they are installed properly.
• To avoid any potential risk of injury, handle them carefully.
CAUTION!
The control devices shall always be kept out of reach for the patient. When the opera-
tor is not using the devices, they must be moved away from the patient.
CAUTION!
When the system is switched off, always wait at least 15 seconds before switching it
on again.
Note!
The system shall only be operated by trained radiographers, service technicians and product
specialists.
Operator´s Manual
2020-09-18
Operating the system
0180-095-418-EN Rev. 6.1
Page 79
General
OMNERA®

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents