Operating the system
Operating the Table
CAUTION!
• Handle the tray carefully when returning it into the detector holder.
• Confirm that the tray is not leaning to one side.
Note!
Assure that the detector tray is pushed in completely to the end position.
4.4.5.2 Method to Remove the 17x17 Detector, Table
The method of removing the detector from the detector holder, is as follows.
1. Pull out the detector tray.
2. Grip the detector and lift it at the same time as you pull it toward you.
3. Reload the tray inside the detector holder by pressing the black button and pushing the
tray inside the detector holder until it is in position.
1
2
OMNERA®
0180-095-418-EN Rev. 6.1
Page 98
Operator´s Manual
2020-09-18