Advertisement
20.3 Preventive Maintenance Performed by the User
20.3.1 Cleaning the system
CAUTION:
NOTICE:
Do not use solvents (such as paint thinner, benzine, or alcohol) or
abrasive cleansers to clean the system. These substances may cause
deterioration or discoloration of the system.
Cleaning the transducer
Cleaning the transducer holder and gel holder
1. Before cleaning the system, be sure to disconnect the
system power plug from the outlet of the facility.
If the system is defective, an electric shock may occur.
2. Do not spill or spray liquids such as water onto the system
or peripheral units. If a liquid such as water enters the
system or peripheral units, an electric shock may occur.
3. Do not use any chemicals or methods other than those
specified to clean the system.
If this is not observed, deterioration or discoloration of the
surface of the system may result.
Clean, disinfect, and sterilize the transducer referring
to the operation manual provided with the
transducer.
(a) Wipe off any stains on the transducer holder
and gel holder using a soft, dry cloth.
(b) If it is difficult to remove stains, wipe them off
using a soft cloth moistened with mild
detergent.
No. 2B771-447EN*F
254
Advertisement
