17X17 Detector, Table - Canon OMNERA 400T Operator's Manual

4.4.5 17x17 Detector, Table

4.4.5.1 Method to Load the 17x17 detector, table
1. Pull the detector tray toward you, until it is completely brought out and locked in its
position.
Note!
• When pulling the detector tray, the button on the side of the tray will first recede before
snapping back into its original position when it locks.
2. Insert the detector into the detector tray as shown below.
Set the detector by pushing it into the tray. Make sure there is a clicking sound at inser-
tion, proving the detector is placed in the correct position.
Note!
It is important to align the detector with the X-ray, by positioning the detector correctly into
the detector tray.
An incorrect detector insertion will lead to incomplete images.
If the detector is chargeable, make sure that the detector contact is connected to the de-
tector holder contact.
3. While pressing and holding the black button of the detector tray, return the tray back into
the inside of the detector holder.
Operator´s Manual
2020-09-18
Operating the system
2. Hold as shown below, and turn the detector
toward you in the arrow direction.
0180-095-418-EN Rev. 6.1
Page 97
Operating the Table
OMNERA®