Table of Contents
Advertisement
3.2.3 Mounting
The LTX has two mounting holes for a M3.5 screw or #6 ANSI/ASME screw. Do not exceed a tightening force of 2.3 Nm (20 in Lbs). A
suitable thread locking agent is advised.
The LTX has three reference surfaces which may be used to align the head for optimal performance. The primary surface A is formed by
the raised mounts on bottom of the head. The second B is the front of the head and the third closest to the emitter.
When mounting the head the goal is to have the Reference Surface B parallel as possible to the plane of the target. Take care when using
mechanical blocks etc to set up the laser as the window may be scratched.
Measurement Set Up
Page 12 of 15
503158 ISSUE 3
EDCR21694
Advertisement
Table of Contents
