Module Specific Configuration Errors - Spectrum Controls Micro800 User Manual

Expansion i/o; analog combination i/o module
Hide thumbs Also See for Micro800:
Table of Contents

Advertisement

3-32
Chapter 3: Configuring the 2085-IF4XOF4-SC Using CCW
Fault Code
Extended Fault Code
0×304
0×305
0×306
0×307
Fault Code
Extended Fault Code
Output Configuration Error
0×410-413
0×420-423
0×F2Bz
18
0×430-433
Input Configuration Error
0×440-443
z indicates the slot number of the expansion I/O. If z=0, then the slot number cannot be identified
18
User's Manual Pub. 0300307-01 Rev. A
Error Description
ADC or PGA communications error
DAC communications error
Not used
15 V power supply to output drivers not available.
The extended fault code is only available when connecting with the Micro850
Series A & B PLCs and Micro870 Series A PLC with its PLC firmware revision
11.011 and above. The extended fault code will show as 0×0000 if connecting
with the Micro850 Series A PLC and its PLC firmware revision 10.011 and
under.

3.10.2 Module Specific Configuration Errors

If you attempt to set the fields in the configuration file to invalid (unsupported)
values, the module generates a non-critical error:
The CCW connection status is faulted
The module is disconnected as Offline mode
If any of the following faults has happened, look up the Configuration Table to
use appropriate values.
Error Description
Invalid Output Range
The Range setting is not within the valid selectable
range. See Configuration Table for possible values.
Invalid Clamp Setup
The High or Low Clamp bit setup is out of range.
Invalid Clamp Value
The High Clamp value is less than or equal to the
Low Clamp value.
The High Clamp value is greater than the High
Limit value of the selected range type.
The Low Clamp value is less than the Low Limit
value of the selected range type.
Invalid Input Range
The Range setting is not within the valid selectable
range. See Configuration Table for possible values.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Micro800 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

2085-if4xof4-sc

Table of Contents