Software Information; Software Versioning; Software Updates - Spectrum Controls Micro800 User Manual

Expansion i/o; analog combination i/o module

Hide thumbs Also See for Micro800:

Table of Contents

3-12

Chapter 3: Configuring the 2085-IF4XOF4-SC Using CCW

Software Information

It is recommended that before manually or automatically pasting your configuration settings to the textbox

of the CCW Configuration tab, be sure to select the Hex Radix indication on both software packages. The

CCW software is unable to receive negative values under Decimal Radix indication.

User's Manual Pub. 0300307-01 Rev. A

8. You can manually copy the settings and paste it to the textbox of the

CCW Configuration tab

9. To automatically copy the generated settings into the textbox of the

CCW Configuration tab, have the textbox visible on the monitor screen,

and then click Copy to CCW button

The utility copies the configuration settings and shows it inside the

textbox.

10. Download the CCW project to controller and start to run the module

operation.

The software version tracks major and minor revisions for end users.

The shipped software version begins at version 1.1.

Once released, the major revision is typically incremented if new features are

introduced to the product. Otherwise only the minor revision is incremented.

In-field updating of the software by the end user is not supported.

Table of Contents

Do you have a question about the Micro800 and is the answer not in the manual?

2085-if4xof4-sc