Output Specifications - Spectrum Controls Micro800 User Manual

Parameter
REACH

Output Specifications

Table 1-2. Output/Performance/Environmental Requirements
Output Description
Outputs per module
Hardware output ranges
Current output impedance
Voltage output impedance
Output Overvoltage Protection
Output Short Circuit Protection
in current mode
Output short circuit protection
in voltage mode
Resolution in current mode
Resolution in voltage mode
Peak Inrush Current
Current accuracy
(calibrated)
0-20 mA
4-20 mA
The load on each channel must be within the range of 50-500 Ohm in current mode and greater than 1
2
Kohm in voltage mode.
Output driver to 0-24 mA (2085sc-OF8 is 0-24.5 mA)
3
Output driver to set ±12 V
4
Output driver set to ±6 V for 0-5 V range and 0-12 V for 0-10 V range
5
Specification
Meets European REACH 7 requirements.
The 2085-IF4XOF4-SC module has the following output specifications:
Value
4 current or voltage outputs. Each channel can only output either
current or voltage at one time.
Current:
2
0-20 mA (0-20.4 mA hardware support range)
4-20 mA (3.92-20.4 mA hardware support range)
Voltage:
0-5 (Over range is 0 V to 5.25 V)
0-10 V (Over range is 0 V to 10.5 V)
±10 V (Over range is -10.5 V to +10.5 V)
More than 1 Mohm
Less than 1 ohm
±24 VDC
Current outputs are electronically current limited to 20.4 mA or
less with no damage
Output current will be limited at 15 mA
735 nA/bit
±10 V: 735 uV/bit; 0-5 V and 0-10 V: 368 uV/bit
Less than 150 mA at 5 V (backplane)
Less than 500 mA at 24 V (backplane)
Error at 25 °C, Max
±50 µA
±50 µA
Chapter 1: Module Overview
3
Error over -20 °C to 65 °C, M
ax
±75 µA
±75 µA
User's Manual Pub. 0300307-01 Rev. A
4
5
1-5