Cli Error Messages - ATTO Technology FastStream VT 5300 Installation And Operation Manual

Designation
sb
sl
st

CLI error messages

The following error messages may be returned by the Command line Interface
ERROR. Invalid Command. Type 'Help' for command list.
ERROR. Wrong/Missing Parameters
Usage: <usage string>
ERROR Invalid RAID Group state
ERROR Invalid Block Device index
ERROR Invalid RAID Member index
ERROR Maximum number of RAID Groups exceeded
ERROR Insufficient number of RAID Group members
ERROR
Block Device at specified index no longer available
ERROR Insufficient RAID Group members for RAID type
CLI summary
The following chart summarizes the Command
Line Interface commands, their defaults, and an
example of how to enter the commands.
CAUTION CAUTION
Do not use CLI unless you are directed to by an ATTO technician. Changing parameters may
cause loss of data and/or disruption to performance and reliability of the FastStream.
The ExpressNAV interface is the preferred method to operate and manage the FastStream VT.
Refer to Interface options
Command
AutoMap
AutoResume
BlockDevClean
BlockDevIdentify
BlockDevIDStop
BlockDevScan
BridgeModel
BridgeName
ClearEventLog
Date
DefaultInterleave
Indicates
SCSI bus number (1<= sb <= 2)
SCSI lun ID (0 <= sl <= 7)
SCSI target ID (0 <= st <= 15)
Commands which have no default values have a
blank entry in that column of the table.
on page 27 for details.
Default
all enabled
" "
01/01/2000
128
Example
automap
set autoresume all disabled
blockdevclean 1
blockdevidentify 1
blockdevidstop
blockdevscan
get bridgemodel
set bridgename Omega6
cleareventlog
set date 03/03/03
set defaultinterleave 64
viii
Appendix