ATTO Technology FastStream VT 5300 Installation And Operation Manual page 48

FCDataRate
Specifies the rate the FastStream uses, 1 Gigabit/sec., 2
Gigabit/sec. 4 Gigabit/sec. or auto negotiate.
Default: auto
set FCDataRate [fp |all ] [1Gb | 2Gb | 4Gb | auto]
Requires a SaveConfiguration Restart command
get FCDataRate [fp | all ]
FCHard
Used to enable or disable FC hard address assignment.
Under soft addressing, the FastStream loop address is
assigned during loop initialization.If you enable hard
addressing use FCHardAddress (described below).
Default: disabled
set FCHard [enabled | disabled]
Requires a SaveConfiguration Restart command
get FCHard
FCHardAddress
Sets/displays the value used as the FC-AL hard address.
This hexadecimal value represents the address the
FastStream tries to use if hard addressing is enabled.
When an address is not set, the current value is displayed.
The valid range of values is 0 through 125.
Default
fp1=3; fp2=4
set FCHard Address [fp | [address]]
Requires a SaveConfiguration Restart command
get FCHardAddress [fp | all ]
FCMultiNode
When enabled (multi node), each port reports a separate
unique Node Name and logical units may be mapped to
any port. When disabled (single node), each port reports
the same Node Name and each logical unit map is applied
to all ports.
Note
Changing the state of this parameter deletes
all existing maps. Add new maps using the
AutoMap or Route
Default: disabled
set FCMultiNode [enabled | disabled]
Requires a SaveConfiguration command
get FCMultiNode
FCPortErrors
Displays the number of Fibre Channel errors that have
occurred since the last reboot/power-on or use of the
ResetFCPortErrors command.
get FCPortErrors
xv
ATTO Technology Inc. FastStream VT 5300 Installation and Operation Manual
commands.
FCPortList
Returns a list of available FC ports and their current
status. Valid status values are Up, Down, Failed,
Reserved and Disabled.
FCPortList
FCSCSIBusyStatus
Chooses to report BUSY or QUEUE FULL when a
unit is unable to accept a SCSI command.
Default: busy
set FCSCSIBusyStatus [busy | qfull]
Requires a SaveConfiguration command
get FCSCSIBusyStatus
FCWWName
Reports the Word Wide Name (WWN) of the FC interface.
Each FC port has an individual and unique WWN. The
least significant 3 bytes of the WWN are used as the
Ethernet MAC address. The lower nibble of the highest
byte designates the port number.
get FCWWN [fp | all ]
FirmwareRestart
Resets and reinitializes the unit firmware. Use the forced
option to override any CLI reservations held by other
sessions.
FirmwareRestart <forced>
Help
Displays a list of available commands. If command name
is specified, displays detailed command-specific
information.
Help <command name>
HSAdd
Assigns a block device to the Hot Spare pool.
HSAdd [BlockDevID]
HSDisplay
Lists all devices in the Hot Spare pool.
HSDisplay
HSRemove
Removes a block device from the Hot Spare pool
HSRemove [BlockDevID]