ATTO Technology FastStream VT 5300 Installation And Operation Manual page 53

SCSIPortResetOnStartup
Specifies if the SCSI port should be reset on power-up.
Default: enabled
set SCSIPortResetOnStartup [sb] [enabled | disabled]
Requires a SaveConfiguration command
get SCSIPortResetOnStartup [sb]
SCSIPortSyncTransfer
Specifies whether synchronous SCSI transfers should be
negotiated with devices on the specified SCSI port.
Default: enabled
set SCSIPortSyncTransfer [sb] [enabled | disabled]
Requires a SaveConfiguration command
get SCSIPortSyncTransfer [sb]
SCSIPortTermination
Configures/reports the SCSI internal termination of the
SCSI port identified on the FastStream.
Default: enabled
set SCSIPortTermination [sb] [enabled | disabled]
Requires a SaveConfiguration command
get SCSIPortTermination [sb]
SCSIPortWideTransfer
Specifies whether wide SCSI transfers should be
negotiated. Enabled allows wide transfer negotiation
Default: enabled
set SCSIPortWideTransfer [sb] [enabled | disabled ]
Requires a SaveConfiguration command
get SCSIPortWideTransfer
SCSITargetLUNs
Sets the maximum number of SCSI LUNs per target the
FastStream tries to query during a SCSI bus scan.
Default: 8
set SCSITargetLUNs [sb] [8 | 64]
Requires a SaveConfiguration command
get SCSITargetLUNs
SCSITargets
Lists SCSI devices connected and operating on the
referenced SCSI port with SCSI target number, SCSI
LUN number, device type, vendor ID, product ID,
revision and serial number.
SCSITargets [sb]
SerialNumber
Reports the FastStream serial number which is unique for
each FastStream. The serial number tracks the board
throughout its life and should not be changed.
get SerialNumber
SerialPortBaudRate
Configures the baud rate for the unit's RS-232 serial port.
The number of data bits is fixed at 8 with no parity.
Default: 115200
set SerialPortBaudRate [ 9600 | 19200 | 38400 | 57600 |
115200]
Requires a SaveConfiguration Restart command
get SerialPortBaudRate
SerialPortEcho
Controls if the unit echoes characters on its RS-232 port.
When enabled, all non-control character keyboard input
is output to the display.
Default: enabled
set SerialPortEcho [enabled | disabled]
get SerialPortEcho
SNTP
Controls whether an SNTP time server is used to set the
FastStream time.
Default: enabled
set SNTP [enabled | disabled]
Requires a SaveConfiguration Restart command
get SNTP
SNTPServer
Controls or displays the main IP address the client uses
to retrieve the SNTP time.
Default: 192.43.244.18
set SNTPServer[xxx.xxx.xxx.xxx]
Requires a SaveConfiguration Restart command
get SNTPServer
TailEventLog
Displays new events to the terminal. Type quit and press
Enter to exit tail mode.
TailEventLog
TapeLibDelete
Deletes the specified tape library or all tape libraries.
TapeLibDelete [GroupName | all]
TapeLibInfo
Lists information for the specified tape library or all tape
libraries.
TapeLibInfo [LibName | all]
xx
Appendix