ATTO Technology FastStream VT 5300 Installation And Operation Manual page 52

RGSpeedRead
Performs look-ahead during reads from RAID group
member disks for all or the specified RAID group.
Default: all disabled
set RGSpeedRead [GroupName | all] [enabled | disabled]
get RGSpeedRead [GroupName | all]
RGWaitTimeout
Specifies the maximum time in seconds that the system
waits to discover previously-configured RAID groups
attached to the drive. The timeout is used during system
boot time and when the BlockDevScan
issued.
Default: 5
set RGWaitTimeout [1-3600]
Requires a SaveConfiguration Restart command
get RGWaitTimeout
RMState
Regulates the state on the specified existing RAID group
member(s). If no Member Index is specified, the status of
all members of the specified RAID group is set.
Note
Members undergoing rebuild are not changed.
Rebuilds on these members must first be
stopped.
set RMState [GroupName] <Member Index> [Online |
Degraded | Unavailable | Faulted]
RMStatus
Displays the status of all RAID members within the
specified RAID group or a specific RAID member (if
specified) within a RAID group.
RMStatus [GroupName] <Member Index>
Route
Assigns a host protocol address to a target destination
device. More than one FC LUN may be assigned to a
partition. If you try to map a new partition to the same FC
LUN, the previous map is overwritten.Use the Delete
identifier to remove the map. In verbose mode,
overwriting a map requires secondary confirmation of
the action.
Route FC [fp] [lun] [ [RAID [GroupName] [Partition Index]]
[ Bridge | Delete ]
xix
ATTO Technology Inc. FastStream VT 5300 Installation and Operation Manual
RouteDisplay
Displays a combined list of host protocol address to
target destination device mappings.
RouteDisplay FC <fp> <lun>
SaveConfiguration
Issued with the restart option, cycles unit power after
saving configuration changes. The norestart option
saves changes without restarting.
command is
SaveConfiguration <Restart | NoRestart>
SCSIDomainValidation
Runs Domain Validation tests on the SCSI system which
may detect problems with SCSI cables, termination or
damaged transceivers. Tape drives attached to the
FastStream should be loaded with media. The media is
not overwritten. Reboot the FastStream after running the
test.
SCSIDomainValidation
SCSIInitID
Specifies or reports the SCSI initiator ID on the specified
SCSI port as found in NVRAM. All maps coinciding with
the user-specified SCSIInitID are destroyed after the
command is issued.
Default: 7
set SCSIInitID [sb [0-15] ]
get SCSIInitID
SCSIPortBusSpeed
Controls the transfer rate at which the unit attempts to
negotiate with its SCSI devices.
Default: ultra320
set SCSIPortBusSpeed [sb] [fast | ultra | ultra2 | ultra160
| ultra320]
get SCSIPortBusSpeed [sb]
SCSIPortList
Lists available SCSI ports and their current status.
SCSIPortList
SCSIPortReset
Resets the specified SCSI bus.
SCSIPortReset [sb]
Note
Certain modifications require a system restart.