Internet Explorer Setup; Begin Initial Configuration - ATTO Technology FastStream VT 5300 Installation And Operation Manual
Fibre channel to scsi virtual tape appliance
Hide thumbs
Also See for FastStream VT 5300:
- Technical specifications (2 pages) ,
- Selection manual (1 page) ,
- Comparison chart (1 page)
Table of Contents
Advertisement
2
Locate the FastStream with the serial number
recorded earlier.
3
Highlight the serial number.
4
Click Next.
If a DHCP server is available on your network,
an address is assigned automatically by the
server. Note the assigned address:
_____________________________________
If you do not have a DHCP server, get an
IPaddress and subnet mask from your network
administrator, type it into the area provided, and
select Next.
5
Click on Launch Browser
Your browser points to the FastStream VT
splash screen. If you use Internet Explorer as a
browser, continue on to
below. If not, continue on to
configuration
.
Internet Explorer setup
1
Open your browser
2
Select Internet Options.
3
In the Internet Options screen, select the
Security tab.
4
Click on the Trusted Sites icon.
5
Click on the Sites button.
6
In the text box Add this Web site to the zone,
add the IP address of the appliance. You may
use wild cards.
7
Click on Add
8
Uncheck the Require server verification
check box.
9
Click OK.
Exhibit 2.0-1 General bracket assembly
Internet Explorer setup
Begin initial
10 At the bottom of the Internet Options box, click
on OK and close the box.
Begin initial configuration
1
The ExpressNAV interface welcome screen
appears. Click on Enter Here
2
Type in the user name and password.
Note
The default user name is root; it is case
insensitive. The default password is
Password; it is case sensitive. It is best
practice to change the passwords. Refer to
Optional system modifications
3
The Initial Setup page appears.
Before creating a Virtual Tape Library, you may
wish to initialize and verify your drives to ensure
drive integrity. Refer to
drives
on page 7.
CAUTION
CAUTION
Selecting Drive Initialization causes all
previous storage data on the drive to be
erased. Make sure all of your information is
backed up before initializing drives.
4
Go on to
Configure Virtual Tape
on page 13.
Initialize and verify
on page 7.
6
Advertisement
Table of Contents
