ATTO Technology FastStream VT 5300 Installation And Operation Manual page 47

EmailFromAddress
Configures the E-mail address that the FastStream uses
to talk to the E-mail server. Full E-mail address is a fully
qualified Internet E-mail address, with no more than 128
characters.
set EmailFromAddress [full email address]
get EmailFromAddress
EmailNotify
Regulates E-mail notification.
Default: disabled.
set EmailNotify [enabled | disabled]
Requires a SaveConfiguration command
get EmailNotify
EmailNotifyAddress
Configures notification addresses using an index (a
number between 1 and 5, inclusive), the full E-mail
address of the recipient, a fully qualified Internet E-mail
address not more than 128 characters long, and a level.
Levels are
None: no E-mails sent.
Critical: critical event notification.
Warning: warnings and critical event notification.
Informational: information notification
All: all warnings, critical events, informational notices
set EmailNotifyAddress [index] [full email address]
[warning level]
get EMailNotifyAddress
EmailPassword
Configures the password used to authenticate the login to
the SMTP E-mail server. The password must not be more
than 64 characters. A password is not required if the E-
mail server does not require authentication.
set EmailPassword
Requires a SaveConfiguration command
EmailServerAddress
Configures the address of the server that the FastStream
should contact in order to send E-mails.
Default: 0.0.0.0
set EmailServerAddress [IP address]
Requires a SaveConfiguration command
get EmailServerAddress
EmailUsername
Configures the user name used to authenticate the login
to the SMTP E-mail server. The user name must not be
more than 128 characters. A user name is not required if
the E-mail server does not require authentication.
set EmailUsername [user name]
Requires a SaveConfiguration command
get EmailUsername
EthernetSpeed
Sets/displays the current speed of the Ethernet
connection. Choices are 10, 100, and Auto.
Default: auto
set EthernetSpeed [mp1] [ 10 | 100 | Auto ]
Requires a SaveConfiguration Restart command
get EthernetSpeed [mp1]
EventLog
When enabled, records various system errors to the event
log.
Default: enabled
set EventLog [enabled | disabled]
get EventLog
EventLogFilter
Filters data from specific unit subsystems and levels when
event logging is enabled. The specific entries supported
are platform-dependent.
Default: all all all
set EventLogFilter [subsys | all] [event level | all] [all |
none]
get EventLogFilter [subsystem | all] [level | all]
Exit
Ends the current Ethernet telnet CLI session; it has no
effect if used during a serial CLI session.
Exit
FCConnMode
Controls/reports the connection mode the FastStream
uses when communication across a FC network, either to
a Fibre Channel Arbitrated Loop (FC-AL) when you
select loop mode, or point-to-point when you choose ptp.
If you choose loop-ptp or ptp-loop, the FastStream tries
to use the first parameter first.
Default: loop
set FCConnMode [fp] [loop | ptp | loop-ptp | ptp-loop]
Requires a SaveConfiguration Restart command
get FCConnMode [fp | all ]
xiv
Appendix