Optional System Modifications; Customize The User Name, Password; Customize System Configurations - ATTO Technology FastStream VT 5300 Installation And Operation Manual
Fibre channel to scsi virtual tape appliance
Hide thumbs
Also See for FastStream VT 5300:
- Technical specifications (2 pages) ,
- Selection manual (1 page) ,
- Comparison chart (1 page)
Table of Contents
Advertisement
2.3 Optional system modifications
Default values are appropriate for most configurations, but may be modified for your needs using the
ExpressNAV interface.
Customize the user name, password
It is best practice to change the default user name
and password.
1
Open a CLI session either using Telnet or the
serial port as shown in
page 27.
2
Type set Username [user name]
3
Press Enter.
4
Type set Password
Customize system configurations
You may change several parameters using the
System Configuration page of the
ExpressNAV interface.
1
If you are not already in the ExpressNAV
interface, type the IP address of your appliance,
as found in
Use the ExpressNAV interface
page 27, in a standard browser, click Enter
Here and type in your user name and
password.
2
The Monitor VTL page appears. In the left-
hand menu, click on the Manage button.
3
In the main splash screen, click on the
FastStream VT menu item.
4
Click on the System Configuration button
13
ATTO Technology Inc. FastStream VT 5300 Installation and Operation Manual
Interface options
on
on
Note
The user name is case insensitive and
password is case sensitive.
5
Press Enter.
6
Follow the instructions on the screen to confirm
your old and new password.
The user name and password for all Telnet, FTP
and ATTO FastStream VT browser-based user
interface sessions is changed.
5
Click on Next.
6
Click on the choices available. A choice may be
greyed out because it is not available based on
a previous choice.
• Appliance name: you may wish to give this
FastStream VT a name which is significant to
you if you are managing several ATTO devices
from a single workstation.
• Time and Date. (Refer to
on page xxi and
Date
Appendix)
• Fibre Channel data rate and connection mode
for each Fibre Channel port. (Refer to
FCDataRate
on page xv and
page xiv of the Appendix).
• Enable or disable hard address assignment
(refer to
FCHard
on page xv of the Appendix)
• Change the SCSI ports' bus speed or initiator ID
(refer to
SCSIPortBusSpeed
page xix of the Appendix
7
When you have completed your changes, click
on Commit.
Time
and
TimeZone
on page xii of the
FCConnMode
on
and
SCSIInitID
on
.
Advertisement
Table of Contents
