ATTO Technology FastStream VT 5300 Installation And Operation Manual page 31

and continue with one of the following
procedures.
Use FTP over Ethernet
1 Establish an FTP link to the ATTO FastStream
VT that is to be flashed.
2 Use the PUT command to download the
firmware. For example
PUT c:\firmware\FS5300100.IMA
3 Once the download is complete, cycle power on
the ATTO FastStream VT to implement the new
firmware.
Use the RS-232 serial link
1 Load a Terminal Program such as Hyper
Terminal.
2 Set the terminal and the ATTO FastStream VT
for the highest possible baud rate for your
terminal.
3 Turn on power to the ATTO FastStream VT.
4 Once the Ready prompt appears, type
ZMODEM RECEIVE. The ATTO FastStream
VT displays that it is preparing to receive a file
from your terminal program.
5 On the terminal program, choose Transfer
Send File
6 In the Send File box, type in the current ATTO
FastStream VT .ima file or click the browse
button to find it
7 Click Send File
8 The ATTO FastStream VT should acknowledge
receiving the file and display a message not to
interrupt power for 90 seconds.
9 Once the download is complete, cycle power on
the ATTO FastStream VT to invoke the new
firmware.
26