Modify System Values; Preliminary Steps; Modify Passwords; Enhance Performance - ATTO Technology FibreBridge 2370E Installation And Operation Manual
Atto fibrebridge operation manual
Hide thumbs
Also See for FibreBridge 2370E:
- Interoperability matrix (1 page) ,
- Specifications (2 pages) ,
- Installation and operation manual (51 pages)
Table of Contents
Advertisement
To configure the ATTO FibreBridge, use ATTO ExpressNAV. Default values are appropriate for most
configurations, but may be modified.
The best way to access the FibreBridge to view and
change settings is to use ATTO ExpressNAV, a
browser-based graphical interface. Other methods are
also available. Refer to
Interface options
Help is available from within ExpressNAV for any
headings displayed in red. For more information on
any of these parameters, refer to the specific CLI
command in
Command explanations
Appendix.
You may make changes to several pages before going
to the Restart page and restarting the FibreBridge to
save the changes.
Preliminary steps
1
If you are not already in
the ExpressNAV
interface, type the IP
address of your
FibreBridge in a
standard browser as
found in
Using
ExpressNAV
on page
27, click Enter Here,
type in your user name
and password, and click
OK .
2
The Status page
appears. Choose the
page you need.
23
ATTO Technology Inc. FibreBridge Installation and Operation Manual
4.0 Modify System Values
on page 27.
on page vi of the
Modify passwords
1
Follow the Preliminary steps.
2
From the side menu select Bridge .
The Bridge Configuration page is displayed.
The Administrator user name that you are
currently logged in with and the current read
only user name, if present, are displayed in
their text boxes.
3
Enter the Administrator ( Admin ) password
where indicated.
4
Enter appropriate information into the New
Admin Password, Confirm New Admin
Password or New Read Only Password and
Confirm New Read Only Password text
boxes.
5
Click Submit.
6
If you have completed all changes for this
session, go to the Restart page and restart the
FibreBridge.
Enhance performance
SpeedWrite is a method to improve the performance
of WRITE commands to SCSI tape devices attached
to the FibreBridge.
Using the CLI command SpeedWrite , you can
specify the SCSI bus, target and LUN of a mapped
device or specify [all] to set or get the state of all
currently mapped SCSI devices.
SpeedWriteDefault specifies the state of
SpeedWrite for any SCSI devices mapped manually
or via an AutoMap operation. If enabled, any new
Advertisement
Table of Contents
