Ericsson HL950 Administrator's Manual page 61

HL950> add interface data ethernet:phy=1, vid=70;
Added ETH interface "eth7"
EXECUTED [0]
HL950> add interface data ethernet:phy=0, vid=80;
Added ETH interface "eth8"
EXECUTED [0]
HL950> add interface data ethernet:phy=1, vid=90;
Added ETH interface "eth9"
Use the delete interface data ethernet command to remove individual virtual
interfaces. (You cannot delete the physical interfaces eth0 or eth1.)
You can configure the virtual Ethernet interfaces in the same way you configure eth0 or eth1.
NOTE!
The physical Ethernet interfaces can be used for both WAN and LAN access, but VLAN
implementation is only for LAN interfaces.
The following example shows the Ethernet specifications for both the physical and the virtual Ethernet
ports:
"eth0" settings:
Started:
Phy Number:
Interface type:
MAC address:
Speed:
DHCP:
IP Address:
Subnet Mask:
Data Mode:
VLAN ID:
Max Transmission Unit:
"eth1" settings:
Started:
Phy Number:
Interface type:
MAC address:
Speed:
DHCP:
IP Address:
Subnet Mask:
Data Mode:
VLAN ID:
Max Transmission Unit:
"eth2" settings:
Started:
Phy Number:
Interface type:
MAC address:
Speed:
DHCP:
IP Address:
Page 61 (159)
No (Link DOWN)
0
LAN
00:80:37:84:F2:6F
Auto-negotiate
No
0.0.0.0
0.0.0.0
Routed
None
1500
Yes (Link DOWN)
1
LAN
00:80:37:84:F2:70
100 Mbps full duplex (auto)
No
192.168.0.1
255.255.255.0
Routed
None
1500
No (Link DOWN)
0
LAN
00:80:37:84:F2:6F
Auto-negotiate
No
0.0.0.0
Multi Service Edge Device HL950
Administrator's Guide
EN/LZT 108 5995 R3
June 2003