Ericsson HL950 Administrator's Manual page 46

Multi Service Edge Device HL950
Administrator's Guide
The HL950 Branch Office configuration (refer to Figure 18):
__________________________________________________________________________________
Ethernet Configuration:
HL950> set interface data ethernet:if=eth0, ip=10.2.20.1,
mask=255.255.255.252, gw=10.2.20.2;
HL950> start interface data ethernet:if=eth0;
LIF E1 Module Configuration:
HL950> set interface line x1:tmode=unframed, cmode=slave;
HL950> start interface line x1
CES Application Configuration:
HL950> add ces ip:name=hl950_2, ip=10.1.10.1, port=2142, payload=256,
cesoip=axerra, clock=external, jb=10;
HL950> start ces ip:name=hl950_2;
__________________________________________________________________________________
Verification tips:
To verify that the CES circuits are up on both sides, use the show ces ip command.
!
Use the show interface data ethernet stats command so that the IP is
!
established between the HL950 and the Edge Router.
To verify that there are no clocking slips, use the show ces ip name=abcd command
!
and see if the under runs or overflows are increasing. Make sure to use this command on the
Branch Office side as well.
EN/LZT 108 5995 R3
June 2003
Page 46 (159)