Ericsson HL950 Administrator's Manual page 32

Multi Service Edge Device HL950
Administrator's Guide
__________________________________________________________________________________
The HL950 Branch Office configuration (refer to Figure 11):
__________________________________________________________________________________
WIF 2x SHDSL Module Configuration:
HL950> set interface wan shdsl ntrmode=ref8k
HL950> start interface wan shdsl
LIF E1 Module Configuration:
HL950> set interface line serial, cts=on, dsr=on, dcd=on, txcsrc=int,
rxcsrc=txc
HL950> start interface line serial
ATM VCC Configuration:
HL950> add interface atm vcc name=dslam, type=aal1, vcc=0/40, srvtype=cbr,
pcr=578000
CES Application Configuration:
HL950> add ces atm name=hl950_2, vcname=dslam, type=udt, clock=network,
jb=10, speed=8
HL950> start ces atm name=hl950_2
__________________________________________________________________________________
Verification tips:
To verify that the CES circuits are up on both sides, use the show ces atm command.
!
Use the show interface atm vcc stats command so that the PVC is established
!
between the HL950 and the DSLAM.
To verify that there are no clocking slips, use the show ces atm name=abcd command
!
and see if the under runs or overflows are increasing. Make sure to use this command on the
Branch Office side as well.
EN/LZT 108 5995 R3
June 2003
Page 32 (159)