Download Print this page
Ericsson HL950 Quick Installation Manual

Ericsson HL950 Quick Installation Manual

Multi-service edge device

Advertisement

Quick Links

Multi-Service Edge Device
HL950
Quick Installation Guide

Advertisement

loading
Need help?

Need help?

Do you have a question about the HL950 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Ericsson HL950

  • Page 1 Multi-Service Edge Device HL950 Quick Installation Guide...
  • Page 2: Table Of Contents

    POWER UP AND INITIAL CONFIGURATION ......11 PRODUCT SPECIFICATION ..14 IMPORTANT INFORMATION ..16 This manual is published by Ericsson AB, without any warranty. Improve- ments and changes to this manual ne- cessitated by typographical errors, in- accuracies of current information, or...
  • Page 3: Introduction

    INTRODUCTION Quick Installation Guide Command Reference Manual PACKAGE CONTENTS Introduction...
  • Page 4: Placement

    PLACEMENT DESKTOP PLACEMENT RACK MOUNTING Figure: Rack mounting kit When mounting the HL950 in a rack, leave a minimum of 1 inch (2,54 cm) space above the unit to ensure proper cooling. Placement...
  • Page 5 Figure: Bracket attachment - Front Panel forward Figure: Bracket attachment - Rear Panel forward Figure: Installation in Rack Placement...
  • Page 6 When the HL950 is rack mounted it is recommended that you ground the unit as described below. Earth (ground) terminal (nut M6) Figure: Earth (ground) terminal Placement...
  • Page 7: Cable Connection

    CABLE CONNECTION CONNECT A CONSOLE TERMINAL CONSOLE port Figure: Connectors/indicators on the HL950 CONNECT THE ETHERNET NETWORK Ethernet 1 port Figure: Connectors/indicators on the HL950 Cable Connection...
  • Page 8 CONNECT THE WAN INTERFACE Figure: Connectors/indicators on the Dual SHDSL Interface Module Connector 1 is implemented for single channel SHDSL over one twisted pair or dual channel SHDSL over two twisted pairs in the same cable. For dual-channel SHDSL with separate cables for each channel, connect the RJ11 SHDSL cable (provided) to connector 1 and a second RJ11 SHDSL cable (not provided) to connector 2.
  • Page 9 Remember to change the strapping on the E1 card when using 75 ohms unbalanced operation. The procedure is described below. RJ45 DIN 1.0/2.3 Connector Connectors Figure: Connectors/indicators on the E1 Interface Module Cable Connection...
  • Page 10 Figure: Jumper settings on the E1 card for 75 ohms unbalanced operation CONNECT TO AN AC POWER OUTLET Cable Connection...
  • Page 11: Power Up And Initial Configuration

    POWER UP AND INITIAL CONFIGURATION POWER UP PERFORM INITIAL CONFIGURATION Power Up and Initial Configuration...
  • Page 12 Console Ethernet 1 port port Fixed IP address (192.168.0.2) SHDSL WAN Figure: System setup for Initial Configuration Power Up and Initial Configuration...
  • Page 13 PERFORM ADDITIONAL CONFIGURATION Com- mand Reference Manual Power Up and Initial Configuration...
  • Page 14: Product Specification

    PRODUCT SPECIFICATION BASE UNIT WAN INTERFACE LEGACY INTERFACES Product Specification...
  • Page 15 PHYSICAL Product Specification...
  • Page 16: Important Information

    IMPORTANT INFORMATION PRODUCT CARE AND MAINTENANCE Read this information before using your Ericsson Multi Serv- ice Edge Device HL950 for safe and efficient use. Important Information...
  • Page 17 LICENCE AGREEMENT Important Information...
  • Page 18 Important Information...
  • Page 19 REGULATORY INFORMATION Important Information...
  • Page 20 © Ericsson AB 2002 EN/LZT 108 5945 R3...