Ericsson HL950 Administrator's Manual page 28

Multi Service Edge Device HL950
Administrator's Guide
ATM VCC Configuration:
HL950> add interface atm vcc:name=dslam, type=aal1, vcc=0/40, srvtype=cbr,
pcr=2309500;
CES Application Configuration:
HL950> add ces atm:name=hl950_1, vcname=dslam, speed=e1, type=udt,
clock=network, jb=10;
HL950> start ces atm:name=hl950_1;
__________________________________________________________________________________
The HL950 Branch Office configuration (refer to Figure 9):
__________________________________________________________________________________
WIF 2x SHDSL Module Configuration:
HL950> set interface wan shdsl:ntrmode=ref8k;
HL950> start interface wan shdsl
LIF E1 Module Configuration:
HL950> set interface line x1:tmode=unframed, cmode=master;
HL950> start interface line x1
ATM VCC Configuration:
HL950> add interface atm vcc:name=dslam, type=aal1, vcc=0/40, srvtype=cbr,
pcr= 2309500;
CES Application Configuration:
HL950> add ces atm:name=hl950_2, vcname=dslam, speed=e1, type=udt,
clock=network, jb=10;
HL950> start ces atm:name=hl950_2;
__________________________________________________________________________________
Verification tips:
To verify that the CES circuits are up on both sides, use the show ces atm command.
!
Use the show interface atm vcc stats command to verify that the PVC is
!
established between the HL950 and the DSLAM.
To verify that there are no clocking slips, use the show ces atm name=abcd command
!
and see if the under runs or overflows are increasing. Make sure to use this command on the
Branch Office side as well.
EN/LZT 108 5995 R3
June 2003
Page 28 (159)