Table of Contents
Advertisement
FPC 6000
Web Page
FPC 6000 Web Page
5
This section of the user guide provides information about:
FPC 6000 Web Page
•
Updating the Firmware
•
To access the FPC 6000 embedded web page, enter the IP address of the unit into the web
browser of a PC connected to the same subnet. A dialog box opens asking for your user name
(by default this is
admin
) and password.
NOTES:
•
The factory configured passwords for all accounts on this device have been set to the
device serial number. Passwords are case sensitive.
•
If the device is reset to default settings, the password will be the default password
configuration. The default password is extron.
•
To change the password, you must use the Extron Toolbelt utility (see the Toolbelt
Help File). Talk to your Extron rep about obtaining a license for Toolbelt.
This page provides general and network information about the unit. When logged in as a user,
the page is read-only. When logged in as an Admin, the user has options to edit ALL information
and update the unit firmware (see figure 15). Use the
the touchpanel network settings.
Figure 15.
FPC 6000 Web Page
Setup Menu
(see page 13) to configure
192.168.254.251
FPC 6000 • Web Page
19
Advertisement
Table of Contents
Need help?
Do you have a question about the FPC 6000 and is the answer not in the manual?
Questions and answers