Extron electronics FPC 6000 User Manual page 46

NOTES:
The screen goes black with a message Project Not Running. The FPC 6000 cannot be
accessed from the front panel and the IP address has been changed.
Press the rear panel Menu button (see
Setup
Once the IP address has been reset, use a PC to open the FPC 6000 web page and reinstall the
latest firmware (see
Once the firmware is installed, the FPC 6000 functions normally.
Enable or Disable the DHCP Client
This mode toggles between DHCP enabled and DHCP disabled. This can also be carried out
from the Network screen of the
Activation
To enable or disable the DHCP client for the LAN port:
1.
2.
Result
•
•
NOTES:
•
The factory configured passwords for all accounts on this device have been set to the
device serial number. Passwords are case sensitive.
•
If the device is reset to default settings, the password is the default password
configuration. The default password is extron.
•
To change the password, you must use the Extron Toolbelt utility (see the Toolbelt
Help File). Talk to your Extron rep about obtaining a license for Toolbelt.
menu (see page 14) to reset the IP address.
Updating Firmware Using the Touchpanel Web Page
see Setup Menu on page
Press the RESET button five times (consecutively).
Release the button. Do not press the button within 3 seconds, following the fifth press.
If DHCP was enabled, it is now disabled. The Reset LED blinks three times.
If DHCP was disabled, it is now enabled. The Reset LED blinks six times.
•
DHCP toggle mode is supported on firmware version 3.0 or higher.
• By default DHCP is off and the unit uses a static IP address.
• When you disable DHCP, the unit reverts to using the previously-set static IP address.
figure 5, C on page 10). Use the
13.
FPC 6000 • Reset Modes
Network page of the
on page 21).
38