Reset All Ip Settings; Activation; Result; Reset To Factory Defaults - Extron electronics FPC 6000 User Manual

Reset All IP Settings

This mode resets all IP settings to factory defaults.

Activation

To reset all IP settings:
1.
2.

Result

Reset All IP Settings mode:
•
•
•
•
•
The screen goes black with a message Project Not Running. The FPC 6000 cannot be
accessed from the front panel and the IP address has been changed.
Press the rear panel
Setup
Once the IP address has been reset, use a PC to open the FPC 6000 web page and reinstall the
latest firmware (see
Once the firmware is installed, the FPC 6000 functions normally.

Reset to Factory Defaults

This mode resets all IP settings and touchpanel settings to factory defaults and removes all
configurations. It allows you to start over with configuration and uploading.
Activation
To reset the unit to all factory default settings:
1.
2.
Result
Reset to Factory Defaults mode performs a complete reset to factory defaults (except the
firmware):
•
•
•
•
Hold down the Reset button (see
Power LED blinks twice (once at 3 seconds and again at 6 seconds).
Release and press Reset momentarily (for <1 second) within 1 second. Nothing happens if
the momentary press does not occur within 1 second.
Sets the IP address back to factory default (192.168.254.251).
Sets the subnet back to factory default (255.255.255.0).
Sets the default gateway address to the factory default (0.0.0.0).
Sets all other IP settings, addresses, and domain and host names back to factory default.
Turns DHCP off.
button (see
Menu
menu (see page 14) to reset the IP address.
Updating Firmware Using the Touchpanel Web Page
Hold down the Reset button for about 9 seconds until the Power LED blinks three times
(once at 3 seconds, again at 6 seconds, and again at 9 seconds).
Release and press Reset momentarily (for <1 second) within 1 second. Nothing happens if
the momentary press does not occur within 1 second.
Does everything Reset All IP Settings mode does.
Removes touchpanel user interface layout and configurations.
Resets all touchpanel settings to factory default.
Resets passwords to default
figure 5, , on page 10) for about 6 seconds until the
B
figure 5, on page 10). Use the
C
FPC 6000 • Reset Modes
Network page of the
on page 21).
37