Table of Contents
Advertisement
Use the Mute/Unmute button (see
output that has been selected.
NOTES:
•
When selected, the button lights up.
•
After 30 seconds with no front panel activity, all buttons time out.
•
After 3 minutes with no front panel activity, the panel enters saving mode. The
touchpanel becomes active again when it detects motion in front of the screen. (This
timeout can be changed.)
Signal Selection Buttons
These buttons (
decide to switch all signals (Video, Audio and USB) together, or select single or multiple signal
types for breakaway switching.
NOTE:
Mute/Unmute Button
When you select an output button, the mute/unmute button (
allows you to mute both the video and audio being sent to the selected output.
When you mute the audio and video, the output button shows a diagonal line through the audio
and video icons (compare unmuted output 1 and muted output 2 in figure 26).
1
O u t p u t 1
Figure 26.
Select All
To create potential ties from a selected input to all outputs, press Select All (
go into effect, press the Take button.
NOTE:
become the Take button and the button that was labeled Take is renamed to become the
Break button.
Take
When you link an input and an output, using the Ties screen, you create a potential tie. For the
tie to go into effect, press the Take button (
Break
This button is not available on the default screen. It only becomes available when you select an
input and press Select All.
Press Take to form ties between the selected input and all outputs. Or press Break to break all
previously existing ties to the selected input.
Clear Selection
Ties created on this screen do not go into effect until they are saved by pressing Take. To undo
ties before they have been saved, press the Clear Selection button (
figure
G
) are designed to select the matrix signal type being controlled. The user can
FOX3 USB breakaway switching requires a Matrix LinkLicense.
2
O u t p u t 2
Unmuted and Muted Outputs
When you select an input and press Select All, the Mute button is renamed to
23,
on page 24) to change the mute status of an
H
H
) becomes active. This button
I
).
FPC 6000 • Operation
). For the ties to
J
K
).
26
Advertisement
Table of Contents
Need help?
Do you have a question about the FPC 6000 and is the answer not in the manual?
Questions and answers