Magnetos; Cleaning; Exterior Painted Surfaces - Beechcraft Musketeer Sport III A23-19 Pilot Operating Handbook

BEECHCRAFT Sport III
MusketeerA23-19. 19A
Section VIII
Handling, Serv- Maint
MAGNETO S
Ordinarily, the magnetos will require only occasional
adjustment, lubrication, and breaker point replacement .
This wark should be dane by a BEECHCRAFT Aero or
Aviation Center or International Distributor or Dealer .
WARNIN G
To be safe, treat the magnetos as hot
whenever a switch lead is disconnected at any
point; they do not have an interna! automatic
grounding device. The magnetos can be
grounded by replacing the switch lead at the
noise filter capacitor with a wire which is
grounded to the engine case . Otherwise, all
s park plug Ie ad s should be disconnected ort he
cable outlet plate on the rear of the magneto
should be removed.
CLEANING
EXTERIOR PAINTED SURFACES
CAUTION
Do not apply wax or polish for a pa int cure
period of 90 days after delivery. Waxes and
polishes seal the paint from the air and prevent
curing . Wash uncured painted surfaces with
cold or lukewarm water and a MILO NON-
DETERGENT SOAP. Any rubbing of t he surface
should be dane gently and held to a minimum
to avoid cracking the paint film.
October 1 979
8-19