$aa9nttss
Applies to: ED-560
Description:
Command to set the specified channel full scale range configuration.
Command Syntax:
$
Delimiter character
aa
Address of the device to be configured in hexadecimal format (
Command to set the channel range code
9
n
Command to specify the input channel where n is the input channel number
Command to specify the type code where tt is the type code from the 'Range settings and
tt
data formats' table
Command to specify the output slew rate – not implemented on current firmware, use a value
ss
of 00 to ensure that the behaviour does not change when the feature is added.
Checksum, if enabled
[CS]
Carriage Return
(CR)
Response
:
!aa[CS](CR)
Valid Command:
?aa[CS](CR)
Invalid Command:
Delimiter for a valid command
!
?
Delimiter for an invalid command
Address of the device which responded
aa
Checksum
[CS]
(CR)
Carriage Return
Examples:
Send command to set the first channel to
$01903200(CR)
Command:
!01(CR)
Response:
Send command to set the fourth channel to the 4-20mA range: n=3, tt=31, ss=00
$01933100(CR)
Command:
!01(CR)
Response:
Ethernet Analogue DIO
Product Manual V1.2
$aa9nttss[CS](CR)
the
0-10V range: n=0, tt=32, ss=00
© Copyright Brainboxes Ltd
00
to FF)
Page 71 of 100