Table of Contents
Advertisement
Safe Value
The Safe Value drop down boxes set the state that the output lines will go when the device goes into a
Watchdog state. This ensures that if the controlling device crashes or there is a problem with the
communication to the device, the output lines will always revert to a safe, known state.
When the safe value is set like the pattern below...
...and the device goes into a Watchdog state for whatever reason, IOut 0 will automatically go to 10mA and
VOut 2 will go to 8.42V.
If the device is in the Watchdog state there will be a message at the top of every configuration page warning
about the state.
Device Management page
The Device Management page has 2 options. The first is to restart your device and the second to restore the
factory default settings of the device.
Restart Device
Clicking the 'Restart Device' button will power cycle the device. In order to restart the device, there must be
no connections being made to it. If there is a connection being made to the device, a warning message will be
displayed asking you to close the connection before restarting the device.
Ethernet Analogue DIO
Product Manual V1.3
© Copyright Brainboxes Ltd
Page 51 of 100
Advertisement
Table of Contents
