Table of Contents
Advertisement
Usability Features
The ED range has been designed so that it is as easy as possible to wire up the input/output, serial expansion
and power wires to the terminal blocks and to connect the network cable:
Removable screw terminal blocks make installation easier and quicker.
Colour coded terminal blocks and ports prevent an incorrect connection.
Individually numbered pins simplify the wiring and removes confusion.
Smart Ethernet which automatically detects the polarity of the Ethernet connection so either a
straight through or crossover Ethernet cable can be used.
Built-in functional ground connection to DIN rail.
Power input from 5-30V: dual redundant input enables two power sources to be connected
Can use the 5 Volt power from any computer USB port via the optional cable accessory PW-650.
Technical Specifications
Network connection
10Base-T or 100Base-TX Ethernet connection
-
-
Standard 8P8C ("RJ45") socket connector
TCP/IP protocol stack
-
-
DHCP or static IP address
Automatic transmit/receive crossover detection
-
1500V magnetic isolation
-
Power
-
Wide-range +5 to +30V DC 60mA@24V 1.4W Typical 120mA@24V 2.9W Max
Reverse voltage protected
-
-
ESD and surge protected
-
Earthing connection point
Caution - Do not attempt to operate this product with
!
any other power supply/rating than that specified.
Ethernet Analogue DIO
Product Manual V1.3
© Copyright Brainboxes Ltd
Page 11 of 100
Advertisement
Table of Contents
