Table of Contents
Advertisement
Intel® Server System M50CYP2UR Family System Integration and Service Guide
Appendix E. POST Code Diagnostic LED Decoder
As an aid in troubleshooting a system hang that occurs during a system POST process, the server board
includes a bank of eight POST code diagnostic LEDs on the back edge of the server board.
During the system boot process, Memory Reference Code (MRC) and system BIOS execute a number of
memory initialization and platform configuration routines, each of which is assigned a hex POST code
number.
As each process is started, the given POST code number is displayed to the POST code diagnostic LEDs on
the back edge of the server board.
During a POST system hang, the displayed POST code can be used to identify the last POST routine that was
run before the error occurred, helping to isolate the possible cause of the hang condition.
Each POST code is represented by eight LEDs, four green LEDs and four amber LEDs. The POST codes are
divided into two nibbles, an upper nibble and a lower nibble. The upper nibble bits are represented by
amber diagnostic LEDs and the lower nibble bits are represented by green diagnostics LEDs. If the bit is set,
the corresponding LED is lit. If the bit is clear, the corresponding LED is off. For each set of nibble bits, LED 0
represents the least significant bit (LSB) and LED 3 represents the most significant bit (MSB).
Figure 165. Onboard POST Diagnostic LEDs
Note: Diagnostic LEDs are best read and decoded when viewing the LEDs from the back of the system.
In the following example, the BIOS sends a value of AC to the diagnostic LED decoder. The LEDs are decoded
as shown in the following table.
131
Advertisement
Table of Contents
