Table of Contents
Advertisement
Calibrating the NXP-PLV
This section outlines the steps for calibrating the NXP-PLV. Calibrating the NXP-PLV before its initial
use and after completing a firmware download is recommended.
The touchscreen is already set up in the factory with specific demo touchscreen pages. The first splash
screen that appears indicates the device is receiving power, beginning to load firmware, and preparing to
display the default touchscreen pages (FIG. 24).
FIG. 24
AMX Splash Screen
At any time during the calibration process, press the Cancel button on the left side of
the screen to return to the Setup page.
To calibrate the touchscreen:
1. From the Camera Options page, select the Panel Setup button to access the Setup page (FIG. 25).
FIG. 25
Main Setup page
2. Press the Calibration button on the left side of the Setup page.
3. Follow the instructions on the screen.
4. When finished, press the Exit button at the top left of the page to return to the Camera Options
page.
NXP-PLV Modero PosiTrack Pilot Camera Controller
AMX Splash Screen
(appears during power-up)
Touchscreen Operation
22
Advertisement
Table of Contents
