Table of Contents
Advertisement
FIG. 37
Device Manager dialog showing USB device
3. Confirm that a new USB detection icon (FIG. 38) appears in the lower-right taskbar on the PC
display window.
4. Double-click on the icon to open the Unplug or Eject Hardware window and confirm the AMX
USB LAN LINK has been installed and is operating properly.
A Virtual NetLinx Master (VNM) is used when the target device is not connected to a
physical NetLinx Master. In this situation, the PC takes on the functions of a Master
via a Virtual NetLinx Master. This connection is made by either using the PC's
Ethernet Address (via TCP/IP using a known PC's IP Address as the Master) or
using a direct mini-USB connection to communicate directly to the device.
5. Click the Properties button to view further information about the installed USB driver.
USB
detection
icon
FIG. 38
USB Properties windows
If you see a yellow exclamation point next to the AMX USB LAN LINK device (within
the hardware devices section of the Unplug or Eject Hardware window), stop and
close the USB operation. Reconnect the USB cable to the panel and repeat the setup
procedures.
NXP-PLV Modero PosiTrack Pilot Camera Controller
Within the Device Manager dialog, the AMX USBLAN device appears under Network
Adapters (FIG. 37) and has a unique name such as AMX USB LAN LINK #2. The number
changes depending on which recognized device is currently connected.
Configuring Communication
USB connected device
(showing the
recognized device)
32
Advertisement
Table of Contents
