Table of Contents
Advertisement
Configuring Communication
Using G4 Web Control to Interact with a NXP-PLV
The G4 Web Control feature allows you to use a PC to interact with an NXP-PLV via the web. This
feature works in tandem with the new browser-capable NetLinx Security firmware update (build 300 or
higher). G4 Web Control is only available with the latest firmware.
Verify your NetLinx Master (ME260/64 or NI-Series) has been installed with the latest
firmware KIT file from www.amx.com. Refer to your NetLinx Master instruction
manual for more detailed information on the use of the new web-based NetLinx
Security.
1. From the Camera Options or Camera Limits page, press the Panel Setup button to open the Panel
Setup page.
2. Press the Protected Setup button (located on the lower-left of the panel page) to open the Protected
Setup page and display an on-screen keypad.
3. Enter 1988 into the Keypad's password field (1988 is the default password).
Clearing Password #5 on the initial Password Setup page removes the need for you
to enter the default password before accessing the Protected Setup page.
4. Press Done when finished.
5. Press the G4 WebControl button to open the G4 Web Control page (FIG. 45).
FIG. 45
G4 Web Control page
6. Press the Enable/Enabled button until it toggles to Enabled (light blue color).
7. The Network Interface Select field is read-only and displays the method of communication to the
web. Verify you have selected the proper interface connection as this field does not auto-detect
the connection type being used (see below).
8. Press the Web Control Name field to open the Web Name keyboard.
43
Wired is used when a direct Ethernet connection is being used for communication to the web.
NXP-PLV Modero PosiTrack Pilot Camera Controller
Advertisement
Table of Contents
