Table of Contents
Advertisement
Programming
Programming
You can program the NXP-PLV to perform a wide variety of operations using Send_Commands and
variable text commands. Use the commands described in this section to program the touch panel. Refer
to the Axcess Programming Language instruction manual for complete information.
Verify you are using the latest NetLinx Master and Modero firmware and the latest
version of NetLinx Studio and TPDesign4.
The NXP-PLV reserves channels 1-7 and levels 1-11 on Port 1 for hardware
functions. These channels/levels are considered reserved by the device and cannot
be used for button assignments.
Designing Touch Panel Pages
You may create touch panel pages for your NXP-PLV by using TPDesign4. Refer to the TPDesign Touch
Panel Program instruction manual for more information.
Designing touch panel pages for the NXP-PLV requires TPDesign4 v2.8 or higher.
Button Assignments
These button assignments can only be adjusted in TPD4 and not on the NXP-PLV
touchscreen itself.
49
• Button Channel Range
• Button Variable Text Range
• Button States Range
• Level Range
• Address port Range
1 - 4000 Button push and Feedback (per address port)
1 - 4000 (per address port)
1 - 256
(0 = All states; for General buttons, 1 = Off state and 2 = On state)
1 - 600 (Default level value 0 - 255, can be set up to 1 - 65535)
1 - 100
NXP-PLV Modero PosiTrack Pilot Camera Controller
Advertisement
Table of Contents
