Table of Contents
Advertisement
Programming
Level Descriptions (Cont.)
Level
Level 5
Iris - Positional, Middle
knob
Enabled by default.
Level 6
Speed, Far knob
Disabled by default.
Level 7
Pan - Compensated
Enabled by default.
Level 8
Tilt - Compensated
Enabled by default.
Level 9
Zoom, Joystick twist left/
right - Speed
Enabled by default.
Level 10
Focus - Speed, Near
knob (largest)
Disabled by default.
Level 11
Iris - Speed, Middle knob
Disabled by default.
51
Range
Default
Description
0 - 65535
32767
When looking at the left side of the device at the iris
knob, turning counterclockwise increases the level at a
rate proportional to the RPM of the knob. Turning
clockwise decreases the level at a rate proportional to
the RPM of the knob. When rotation stops, level value
stops and holds the current value. From the Setup
Pages, the Iris Sensitivity can be set to High, Medium, or
Low.
2 - 65535
Dependent
When looking at the left side of the device at the speed
on knob
knob, fully counterclockwise provides a level of 2. Fully
location
clockwise provides a level of 65535. Values in between
are proportional to the knob location.
Note: If user attempts to set speed level to a value of 0
or 1, the level assumes a value of 2 (minimum).
0 - 255
127
This level automatically compensates for the position of
the Speed knob. 127 is the mid point and default value.
Minimum and maximum values are dependent on the
current value of the Speed knob.
0 - 255
127
This level automatically compensates for the position of
the Speed knob. 127 is the mid point and default value.
Minimum and maximum values are dependent on the
current value of the Speed knob.
0 - 255
127
127 is the mid point and default value. Twisting
joystick fully to the left yields a level value of zero (0).
Twisting joystick fully to the right yields a level value of
255. Values in between are linearly proportional to the
joystick location.
0 - 255
127
When looking at the left side of the device at the focus
knob, the counterclockwise rotational speed is
proportional to the positive offset from level center (127).
The clockwise rotational speed is proportional to the
negative offset from level center. From the Setup Page,
the Focus Sensitivity can be set to High, Medium, or
Low.
0 - 255
127
When looking at the left side of the device at the iris
knob, the counterclockwise rotational speed is propor-
tional to the positive offset from level center (127). The
clockwise rotational speed is proportional to the negative
offset from level centers.
NXP-PLV Modero PosiTrack Pilot Camera Controller
Advertisement
Table of Contents
