Table of Contents
Advertisement
The latest CV7 firmware kit file is now panel-specific.
Only CV7 firmware should be loaded onto this specific device type.
This new firmware also provides both backwards compatibility with the previous
802.11b cards and new security protocols for the new 802.11g wireless CF card.
5. If the panel firmware being used is not current, download the latest Kit file by first logging in to
www.amx.com and then navigate to Tech Center > Firmware Files. Locate your device from
within the Modero section of the web page.
6. Click on the desired Kit file link. Verify you have downloaded the Modero Kit file to a known
location after you accept the Licensing Agreement.
7. From within Studio, select Tools > Firmware Transfers > Send to NetLinx Device from the Main
menu to open the Send to NetLinx Device dialog (B in FIG. 52). Verify the panel's System and
Device number values match those values listed within the System folder in the OnLine Tree tab of
the Workspace window (A in FIG. 52).
FIG. 52
Using USB for a Virtual Master transfer
8. Select the panel's Kit file from the Files section.
9. Enter the Device value associated with the device and the System number associated with the
Master (listed in the OnLine Tree tab of the Workspace window). The Port field is greyed out.
10. Click the Reboot Device checkbox. This causes the device to reboot after the firmware update
process is complete. The reboot of the device can take up 30 seconds after the firmware process has
finished.
11. Click Send to begin the transfer. The file transfer progress is indicated on the bottom-right of the
dialog (B in FIG. 52).
12. As the device is rebooting, temporarily unplug the USB connector on the device until the device has
completely restarted.
13. Once the first touchscreen page has been displayed, reconnect the USB connector to the device.
NXP-PLV Modero PosiTrack Pilot Camera Controller
A
B
Upgrading NXP-PLV Firmware
106
Advertisement
Table of Contents
