Reserved Level Descriptions - AMX NXP-PLV Operation/Reference Manual

Reserved Level Descriptions

The levels below can be enabled/disabled via Send Commands. The resolutions and ranges can also be
changed via Send Commands. Refer to the Input Commands section on page 96 for further details.
These levels are only applied to Port 1.
Level Descriptions
Level #
1
2
3
4
5
6
7
8
9
10
11
Level Descriptions
Level
Level 1
Pan, Joystick left/right
Disabled by default.
Level 2
Tilt, Joystick Up/Down
Disabled by default.
Level 3
Zoom, Joystick twist left/
right - Positional
Disabled by default.
Level 4
Focus - Positional, Near
knob (largest)
Enabled by default.
NXP-PLV Modero PosiTrack Pilot Camera Controller
Level Name Description
PAN JOYSTICK - LEFT / RIGHT
TILT JOYSTICK - UP/DOWN
ZOOM_POS JOYSTICK - TWIST - POSITIONAL
FOCUS_POS KNOB - NEAR - POSITIONAL
IRIS_POS KNOB - MIDDLE - POSITIONAL
SPEED KNOB - FAR
PAN_COMP PAN - COMPENSATED
TILT_COMP TILT - COMPENSATED
ZOOM_SPD JOYSTICK - TWIST - SPEED
FOCUS_SPD KNOB - NEAR - SPEED MODE
IRIS_SPD KNOB - MIDDLE - SPEED MODE
Range Default
0 - 255 127
0 - 255 127
0 - 65535 32767
0 - 65535 32767
Description
127 is the mid point and default value. Full joystick
deflection to the left yields a level value of zero (0). Full
joystick deflection to the right yields a level value of 255.
Values in between are linearly proportional to the joy-
stick location.
127 is the mid point and default value. Full joystick
deflection down (towards front of unit) yields a level
value of zero (0). Full joystick deflection up (to the rear of
unit) yields a level value of 255. Values in between are
linearly proportional to the joystick location.
The level value increases at a rate proportional to the
joystick twist to the right. The level value decreases at a
rate proportional to the joystick twist to the left. When
joystick is released (centered), level value stops and
holds the current value.
When looking at the left side of the device at the focus
knob, turning counterclockwise increases the level at a
rate proportional to the RPM of the knob. Turning
clockwise decreases the level at a rate proportional to
the RPM of the knob. When rotation stops, level value
stops and holds the current value. From the Setup
Pages, the Focus Sensitivity can be set to High,
Medium, or Low.
Programming
Default Resolution
8 Bit
8 Bit
16 Bit
16 Bit
16 Bit
16 Bit
8 Bit
8 Bit
8 Bit
8 Bit
8 Bit
50