Table of Contents
Advertisement
Touchscreen Operation
The Panel Setup button opens the Panel Setup page. See the Panel Setup section on page 27 for more
information on setting up a connection for your NXP-PLV.
The Camera Options button opens the Camera Options page, as detailed on page 19.
The Exit Config button returns you to the Presets page.
To set limits to a particular camera:
1. Select the camera to be set from the Camera Station pushbuttons to the left of the touchscreen.
2. Move the camera with the joystick and control knobs to the desired position. To return to the
camera's default home position, press the Find Home button.
3. Press the button representing the particular limit you want to save. For instance, if you wish to put a
limit on how far the camera pans to the left, press the set pan left button.
4. When finished, return to the Presets page by pressing the Exit Config button.
5. A new page will open, reading "This will override limits currently set on existing presets!
CONTINUE?" with the choices of Yes or No (FIG. 22). If you press No, or if you wait more than
three seconds to make a choice, the screen will return to the Camera Limits page. If you press Yes,
the camera limit will be saved.
FIG. 22
Override Limits Warning
To clear all previously saved limits on the selected camera:
1. Press one of the three Clear Limits buttons. all clears both pan and tilt limits, while pan and tilt
only clear the respective pan and tilt limits without affecting any others.
2. A new page will open, reading "This can clear all presets! CONTINUE?" with the choices of Yes or
No (FIG. 23). If you press No, or if you wait more than three seconds to make a choice, the screen
will return to the Camera Limits page. If you press Yes, the selected camera limits will be cleared.
FIG. 23
Clear Presets Warning
21
NXP-PLV Modero PosiTrack Pilot Camera Controller
Advertisement
Table of Contents
