Table of Contents
Advertisement
number values match those values listed within the System folder in the OnLine Tree tab of the
Workspace window.
FIG. 55
Send to NetLinx Device dialog (showing Modero firmware update via IP)
7. Select the panel's Kit file from the Files section (FIG. 55).
8. Enter the Device value associated with the device and the System number associated with the
Master (listed in the OnLine Tree tab of the Workspace window). The Port field is greyed-out.
9. Click the Reboot Device checkbox. This causes the device to reboot after the firmware update
process is complete. The reboot of the device can take up to 30 seconds after the firmware process
has finished.
10. Click Send to begin the transfer. The file transfer progress is indicated on the bottom-right of the
dialog (FIG. 55).
11. Click Close after the device reboots to return to the main program.
12. Right-click the associated System number and select Refresh System. This causes a refresh of all
project systems, establishes a new connection to the Master, and populates the System list with
devices on your particular system.
13. Confirm the panel has been properly updated to the correct firmware version.
NXP-PLV Modero PosiTrack Pilot Camera Controller
Upgrading NXP-PLV Firmware
Showing the NetLinx Master
firmware version and
device number
Showing the current firmware
version and device number
Shows NetLinx Studio
version number
110
Advertisement
Table of Contents
