Table of Contents
Advertisement
When the device is detected for the first time, some user intervention is required during the association
between device and driver.
1. After the installation of the USB driver has been completed, confirm the proper installation of the
large Type-A USB connector to the PC's USB port, and restart your machine.
If the device is already powered, continue with step 3.
The device MUST be powered and configured for USB communication before
connecting the mini-USB connector to the device's Program Port.
2. Connect the terminal end of the 12 VDC-compliant power supply cable to the power connector on
the rear/side of the device and then apply power.
3. After the device powers-up, press the Config button on the main page to continue with the setup
process and proceed to the Panel Setup page.
4. Select Protected Setup > System Settings (located on the lower left of the screen) to open the
System Settings page (FIG. 35).
FIG. 35
USB System Settings page - using a USB Connection Type
5. Toggle the blue Type field (from the Master Connection section) until the choice cycles to USB.
Refer to the System Settings section for more information about the fields on this page.
ALL fields are then greyed-out and read-only, but still display any previous network
information.
6. Press the Back button on the screen to return to the Protected Setup page.
7. Press the on-screen Reboot button to both save any changes and restart the device. Remember that
the device's connection type must be set to USB prior to rebooting the device and prior to inserting
the USB connector.
NXP-PLV Modero PosiTrack Pilot Camera Controller
Configuring Communication
No connection is established until
the Virtual Master becomes
active within Studio
Red
Connection Status icon -
indicates no connection to a Virtual
Master
Green
Connection Status icon -
indicates communication to a Virtual
Master
30
Advertisement
Table of Contents
