Internal Components; Additional Accessories; Kits & Keypads; Sensors & Peripherals - 2gig Technologies EDGE Installation Manual

INTERNAL COMPONENTS

This illustration details the 2GIG EDGE Panel's internal components.
2GIG EDGE Panel - Internal Components
B
A
Callout Component
A Third Hand Hanging Strap A durable hanging strap provides installers with an extra hand when installing and
servicing the 2GIG EDGE Panel.
B USB Port A built-in USB port for updating the panel's firmware.
C Piezo Sounder An internal 85-dB Piezo Sounder.
D Terminal Block Two terminal blocks with screw-terminal positions for connecting the 2GIG EDGE Panel to
electrical power (DC IN+/DC IN –), hardwire loops/wired zones (ZONE1/ZONE2), solid state
output (BELL+/BELL-), and an open collector output (OCL1/OCL2).
E Backup Battery A backup battery used with the 2GIG EDGE Panel to extend service during a power outage.
F Receiver Board The main receiver board.
G 2GIG EDGE Speaker An internal speaker that sounds, navigation tones, alert tones, and supports crystal clear
2-Way Voice communication with echo suppression.
2GIG EDGE Installation Guide
C
D
E
F
G
Description
8

Additional Accessories

The installer typically sets up the system to communicate with a variety of wired and/or wireless sensors. Some sensors are visible on the wall
or ceiling, such as Wireless Smoke/Heat/Freeze Alarms and Wireless Carbon Monoxide Detectors. Others may be hidden in door jambs, such as
Recessed Door/Window Contacts. Sensors might also be installed in additional locations, such as a Glass Break Detector and a Passive Infrared
Motion Detector.
NOTE: A variety of 2GIG and GoControl branded devices are compatible with the 2GIG EDGE Security & Smart Home System. Sensors
manufactured by other companies may also be compatible with the system. For information, visit
IMPORTANT: To ensure that the system's sensors are operating properly, it is important for 2GIG alarm dealers and system owners to
ensure sensor batteries and wireless signals are tested at least once a year.
Depending on the specific installation, systems may also be installed with one or more of the following 2GIG accessories:
Kits & Keypads
»
2GIG Control Panel Desktop Kit
»
2GIG EDGE Remote Keypad
»
2GIG PAD1
Antennas
»
2GIG External Mount Antenna
Sensors & Peripherals
»
2GIG Thin Door/Window Surface Contact
»
2GIG Recessed Door/Window Contact
»
2GIG Passive Infrared (PIR) Motion Detector
»
2GIG Glass Break Detector
»
2GIG Smoke/Heat/Freeze Alarm
»
2GIG Smoke/Heat Detector
»
2GIG Panic Button Remote
»
2GIG Carbon Monoxide Sensor
»
2GIG Takeover Module
»
2GIG Doorbell
»
Universal Garage Door Receiver
»
2GIG Tilt Sensor
»
2GIG Bypass Sensor
»
2GIG Flood Sensor
»
2GIG Repeater
NOTE: 2GIG eSeries (encrypted) & unencrypted 2GIG sensors are compatible with eSeries panels including 2GIG EDGE.

Smart Home Controls

Consult your 2GIG alarm dealer for information about installing compatible Z-Wave smart home controls and Video Cameras including:
»
Lights
»
Locks
»
Thermostats
»
Garage Doors
»
Video doorbells
»
IP Cameras
dealer.2gig.com
Copyright © 2021 Nortek Security & Control LLC
9