Control Panel Wiring Diagram; Hang The 2Gig Edge Panel; Install Retaining Wall Bracket And Connect The Ac Power Supply - 2gig Technologies EDGE Installation Manual

Control Panel Wiring Diagram

The following diagram shows the Control Panel wiring.
Control Panel Wiring Diagram
Example
hookup
Open
showing
1 K
Collector
an armed
Output
LED. The
250 mA
Open Colector
@ 16 VDC
output can be
Maximum
programmed
to activate
LED
during various
conditions.
Plug-in 14 VDC
1.7 AMP
Switching
Power Supply
OBSERVE POLARITY
when connecting the
Power Supply
Control
Panel
1
2
3
4
Power provided only
5
when the Control
6
Panel's power supply
is connected to an
7
AC power source
8
2GIG EDGE Installation Guide
Hardware loops can be
programmed as normally
open or normally closed
2.2 K +/- %5 1/4 W
Normally Closed
Contact
End-of-Line
Resistors UL NOTE: Wiring for
are
all wired sensors and
optional
annunciators must
on
use UL Listed low
hardwire
voltage Class 2 or
loops
better grade wire.
2.2 K +/- %5
1/4 W Sensor and display
Normally voltages must comply
Closed with Class 2 low
Contact voltage requirements
systems shall be
installed in
accordance with ANSI/
NFPA 72, CSA C22.1,
CAN/ULC S302 and
CAN/ULC S301.
Supervised
Bell Output
14 VDC
@ 500 mA
Maximum
Piezo
Siren
9 10 3 4 5 6 7 8
GND DC IN
AUX+ DC IN + 9
GND DC IN – 10
11
Bell + OCL1
ALL output
Bell – OCL2 12 voltages are
Class 2
Zone1 TX 13
14
Zone2 RX
GND
24

Hang the 2GIG EDGE Panel

To hang the 2GIG EDGE Panel on the mounting plate:
1 . Ensure all installed wiring is securely fastened.
2 . Place the upper lip of the back of the panel chassis over the back top of the backplate, then flip the Edge Panel downward.
3 . Push the 2GIG EDGE Panel over the mounting bracket until it clicks into place.
4 . Secure the lower set screw.

Install Retaining Wall Bracket and Connect the AC Power Supply

After you have completed all of the required system wiring and connected the battery backup, install the wall bracket and connect the AC power
supply to the wall receptacle.
NOTE: For compliance with ANSI/NFPA 70: National Electric Code in the United States, you must install the power supply
retaining bracket.
To install the wall bracket and connect the AC power supply:
1 . Locate a wall outlet for the plug-in power supply. Do NOT connect the power supply to the receptacle.
IMPORTANT: When selecting a wall outlet, never connect the plug-in power supply to a switch-controlled outlet.
2 . Peel the adhesive backing off the power supply's retaining wall bracket and attach it to the receptacle.
3 . Secure the bracket to the wall using the fastening screw.
4 . Spread the ears of the retaining bracket apart. Then plug the power supply into the outlet.
Standard Style – Center Fastener Decora Style – Center Fastener
Back Plate
Attached to Wall
Secure with Fastener
Copyright © 2021 Nortek Security & Control LLC
25